Front Load Washer No Spin or Agitate

If your Front Load Washer Does Not Agitate or Spin Check The Following Belt The belt may have come off or broke. If you hear the motor running but nothings moving the problem is likely the belt. This is easy to check and replace. Door Switch This can cause the washer to not agitate or go into the spin cycle. You will need to remove the door switch to check it. You will perform an ohm reading on the bottom terminals. The reading varies from manufacturers most Frigidaires is around 1500 ohms others like the whirlpool duet is checked at the main control board with the door closed should be around zero ohms. You will need to refer to the tech sheet or service manual for the proper reading. Main Control Module / CCU The main control unit is the circuit board located behind the console. If the door switch tests good the main control is usually the problem. Check all connections for a goood tight fit. You will need to refer to the tech sheet or service manual to check this further. The main control is easy to replace. Motor Control Module The motor Control Module is located inside the cabinet down near the motor. This recieves the signals from the main control module then relays this information to the motor. Check all connections sometimes a communcation problem is just a loose connection. The Motor Control Module is easy to replace. To check this further you will need to refer to your tech sheet or service manual.

---

Refrigerator 25 Cu. Ft. French Door Bottom-Freezer Refrigerator with EasyFill Internal Water Dispenser	Range 30" Freestanding Electric Range with a 5.4 Cu. Ft. Maxx Capacity and Bake and Warm Double Oven	Whirlpool Gold 27" Duet Front-Load Washer with 3.8 Cu. Ft. Capacity, Stainless Steel Wash Basket
Shop Now	Shop Now	Shop Now