Jenn Air Range / Stove / Oven Fault Codes |
Failure Code |
Fault Code Description |
Solution |
F0 |
Function key stuck |
Replace touch pad or if touch pad is part of the clock, replace the clock (ERC). |
F1 |
Defective touch pad or clock (ERC) |
Replace touch pad or clock (ERC). Touch pad is a more common problem. Refer to F1 test at the top of this page for more information. |
F2 |
Oven temperature too hot |
Replace relay board, if present, or oven temperature sensor (RTD). Check sensor harness. |
F3
or
F4 |
Shorted or open oven temperature sensor (RTD) |
Check sensor harness and harness connection between oven sensor and oven control. Replace oven temperature sensor (RTD) if wiring is ok. |
F5 |
Watchdog and hardware conflict |
Replace clock (ERC). |
F7 |
Function key shorted or stuck |
Replace touch pad or if touch pad is part of the clock, replace the clock (ERC). |
F8 |
Analog / Digital problem |
Replace clock (ERC). |
F9 |
Door latch |
Check door latch components. |
Failure
Code |
Condition |
Check/Repair |
F1 |
Power to element relay energized during time of day display |
Wiring harness shorted or change power relay board (PRB)
Note: for double ovens, change second oven board |
F2 |
Oven temp sensed; over 600F sensed by control in time of day mode, bake mode, or over 900F sensed in clean mode. |
Ohm test the oven temperature sensor, if OK, change power relay board. |
F3 |
Cooling fan on with no oven function selected |
Check oven temperature sensor or wire harness to oven temperature sensor |
F4 |
Shorted oven temperature sensor |
Check oven temperature sensor or wire harness to oven temperature sensor |
F5 |
Power to element relays disabled in cook mode |
1. Intermittent oven temperature sensor or wire harness or,
2. Intermittent contact on power relay board |
F7 |
Shorted key sensed for 32 seconds |
1. Membrane shorted, or,
2. Display board defective |
F8 |
Shorted meat probe alarm |
1. Probe jack or harness to probe jack, or,
2. Probe sensing temp above 250F |
F9 |
Door lock safety circuit on power relay board sensed |
Replace power relay board |
FF |
Invalid temp reading on power relay board (PRB) |
Check oven temperature sensor and wire harness, or replace power relay board |
F |
Communication error between boards |
Wiring harness, check harness wires for continuity, or replace power relay board |
FC |
Communication error between boards |
Wiring harness or power relay board (PRB) |
FR |
Second oven error sensed |
1. Check oven temperature sensor and harness, or,
2. Replace second board |