Front Load Washer Will Not Pump Out

If your Front Load Washer Will Not Pump out the Water Check The Following Drain Pump Filter This is the most common problem. Some have a small cover in the lower front put a screwdriver in the hole and turn counterclockwise to remove. There will be a cover to remove, water will come out so be prepared with a towel or wet vac. Clean this out. Other Machines will need to access the drain pump to get to the filter. This can be done by removing the back panel on some washers. On others you will need to remove the lower panel or complete front panel depending on model. The filter is located inside the large hose from the tub to the pump. Remove the hose and clean filter. Drain Pump The drain pump may have failed. If you hear it making noises you will need to remove the drain pump and check for obstructions, broken impeller, or not spinning freely. Remove obstructions if it does not spin freely replace the drain pump. If you hear it hum replace the pump if nothing is found inside. If no noise is heard check the pump for power. To do this remove the wire connectors and connect a voltmeter turn to a drain cycle, refer to tech sheet or service manual for proper voltage reading, usually any voltage would probally indicate a faulty pump. If no voltage to the pump replace the main control board. Hoses Check the hoses from the pump by disconnecting them and make sure there are no obstructions. Check your hoes drain, if it is a slow drain this can cause your washer to not properly drain.

---

Refrigerator 25 Cu. Ft. French Door Bottom-Freezer Refrigerator with EasyFill Internal Water Dispenser	Range 30" Freestanding Electric Range with a 5.4 Cu. Ft. Maxx Capacity and Bake and Warm Double Oven	Whirlpool Gold 27" Duet Front-Load Washer with 3.8 Cu. Ft. Capacity, Stainless Steel Wash Basket
Shop Now	Shop Now	Shop Now